Tạo Trắc Nghiệm

200+ Trắc nghiệm Cơ điện tử ô tô (có đáp án)

28 câu · Đề ôn tập tổng hợp

1/28 câu đang cập nhật đáp án (ghi rõ ở từng câu), chưa tính điểm; điểm tính trên 27 câu còn lại.

Xem trước: đọc nhanh mọi câu dạng chữ, chưa tính giờ, chưa hiện đáp án.
Luyện tập: chọn đáp án là biết đúng sai ngay, kèm lời giải.
Thi thử: nộp bài mới chấm điểm và hiện lời giải.

Câu 1

. As engine rpm increases, the ignition timing must:

Đáp án và lời giải

Đáp án: C

Câu 2

As engine rpm increases, the ignition timing must:

Đáp án và lời giải

Đáp án: B

Câu 3

Which of the following components generates a timing signal for the ignition system?

Đáp án và lời giải

Đáp án: B

Câu 4

All of the following components are part of a Distributorless Ignition System (DIS) EXCEPT:

Đáp án và lời giải

Đáp án: C

Câu 5

.The HEAT RANGE of a spark plug can be determined by:

Đáp án và lời giải

Đáp án: A

Câu 6

Which of the following components multiplies battery voltage to create a spark?

Đáp án và lời giải

Đáp án: D

Câu 7

.Which of the following can cause changes in Ignition Timing?

Đáp án và lời giải

Đáp án: D

Câu 8

.If the Crankshaft Position Sensor is not producing a signal, what will happen?

Đáp án và lời giải

Đáp án: C

Câu 9

An eight cylinder engine running at 3000 rpm requires    sparks per SECOND.

Đáp án và lời giải

Đáp án: C

Câu 10

In an alternator, alternating current is converted to direct current by the:

Đáp án và lời giải

Đáp án: C

Câu 11

.CDI stands for:

Đáp án và lời giải

Đáp án: D

Câu 12

.A battery that is overcharged can be due to:

Đáp án và lời giải

Đáp án: D

Câu 13

Why is a thermistor used in an alternator regulator?

Đáp án và lời giải

Đáp án: B

Câu 14

.What does EMF stand for?

Đáp án và lời giải

Đáp án: A

Câu 15

Most vehicles today use the    type of ignition system.

Đáp án và lời giải

Đáp án: A

Câu 16

.The type of ignition system in which two cylinders share one coil is called a:

Đáp án và lời giải

Đáp án: C

Câu 17

In an alternator, which component controls the output?

Đáp án và lời giải

Đáp án: D

Câu 18

Phương án trong đề gốc bị lỗi, đang sửa
.The basic purpose of the overrunning clutch in the starter drive is to:
  • Adisengage the armature when the engine starts
  • Bassist the solenoid during cranking.
  • Ckeep the hold-in winding energized during cranking
  • Dpull the starter pinion gear out of mesh
  • Epush-in and hold-out
  • Fpush-in and pull-out.
  • Gpull-in and hold-in
  • Hpull-in and push-out
  • It increase voltage
  • both a and b
  • It distributes high tension current to spark plug at correct time
  • None of the above

Câu này chưa tính điểm. Đáp án sẽ được cập nhật sớm.

Câu 19

In Magneto Ignition system

Đáp án và lời giải

Đáp án: C

Câu 20

.The following is known as ‘Breakerless Ignition system’

Đáp án và lời giải

Đáp án: B

Câu 21

The discharged lead acid battery has on its plates

Đáp án và lời giải

Đáp án: D

Câu 22

The main task of a battery in automobiles is to

Đáp án và lời giải

Đáp án: D

Câu 23

.During charging the specific gravity of the electrolyte of a lead acid battery

Đáp án và lời giải

Đáp án: D

Câu 24

Which component produces the electricity to charge the battery?

Đáp án và lời giải

Đáp án: B

Câu 25

.Which component uses the most amperage in a vehicle?

Đáp án và lời giải

Đáp án: A

Câu 26

What part of a car produces the electricity?

Đáp án và lời giải

Đáp án: C

Câu 27

.SV A nói trong đánh lửa trực tiếp bobine đôi, bougie nào ở kỳ nén sẽ có lửa. SV B nói 2 đầu dây cao áp của bôbine phải nối vào 2 bougie của 2 máy song hành. Ai đúng?

Đáp án và lời giải

Đáp án: B

Câu 28

Các câu dưới về định luật Pashen đều đúng, ngoại trừ:

Đáp án và lời giải

Đáp án: C